SCSI cd rom with AsimCDFS

[tonyvdb]

So I've got my A2000 with an A2091 SCSI card and have a SCSI cd rom drive installed. AsimCDFS sees the drive on SCSI 0 (hard drive is on SCSI 2) but after reboot when I put cd in drive nothing shows up on the workbench? I've placed the CD0 into the devs drawer. Am I missing a step?

[tonyvdb]

No Mike, what should I do?
I have the "information" for the cd0 open as I type this.
Default tool has c:mount
Tooltypes has DONOTWAIT
And that's it

[tonyvdb]

This is at the top of the list:

Device =SCSI.device
Unit =0
Mount =1
Should the mount not also be 0? It shows file system is AsimCDFS so that part is good.

[tonyvdb]

Ok, cd cd0: comes back with nothing.

I'll do some reading and see what I can figure out. AsimCDFS has always worked on my 4000. So this is a bit different with scsi
Drive was working but no way of testing now. It does light up briefly when I insert a cd

[tonyvdb]

Im using OS3.1

[tonyvdb]

Remember asim uses the cd0: icon in storage not in devs/dos drivers.
check storage/dosdrivers/cd0(or whatever its named) for the right device number.. if you picked CD0 in the asim install, it sets unit number to 0.. if you select cd2 its 2,etc. remove any cd0 or anything from devs:dosdrivers.

Really? On the 4000 you have to put the CD0 into the dosdrivers drawer. Im confused.

is the scsi cd drive known to be a working drive?

It was working last time it was used.

[tonyvdb]

Ok, so I got it working. I changed my hard drive to be device 0 and the CD-ROM drive to be device 1 re ran AsimCDFS And all is good.
The a2091 is revision 6.6 rom

[tonyvdb]

Thank you to all who participated in this thread, it was very helpful