Can anybody help me?
I am trying to install a Seagate SCSI Cheetah HDD to my A4000 which has a existing IBM SCSI HDD fitted, Cyberstorm PCC board and OS3.9.(1&2 updates installed)
My problem is this.
The Cheetah drive shows up after scanning for it using the Cyberstorm SCSI software. Using the Cyberstorm or HDD toolbox I save the changes after partitioning etc and then reboot the system in which one should see the partitions show up on the workbench so I can then format them but they don't!
If I go back in to HD Toobox or the Cyberstorm Toolbox the drive has disapeared with only the IBM drive showing.
SO the HDD Tool boxes are not reading the drive on re boot!
I have tried everything like low level formating the drive
making sure it is bootable etc etc
I also tried installing using ther old 3.1 toolbox by changing the tooltype to cybppc device but it will not read the drive at all. The drives have active terminators at each end. The IBM SCSI drive works fine on the same bus.
Can anybody help?
Thanks in advance
The walrus