FS: Amiga500 Amiga1200 PowerSupply New Replacement. $29.95

[efrenmgp]

Pretty sure Mexico and Canada uses same plug as U.S (all in North America after all)
so I will include the 3 prong cord.

Yes they are the exact same

Thanks! I'll be sending paypal payment later today

[RobertB]

Not sure what gauge...

From Ray Carlsen,

"...the wires in that [original A500 PS] cable are pretty thin, same as in a C128 PS cable... copper is expensive. Commodore got around that by installing a "sense" line, the fifth wire in the cable. It provides feedback to the PS board so that when the load on the +5VDC is increased (computer on) the PS feeds out a little more voltage to compensate.

The new [modern] power module has no such sense line, so I use heavier gauge wire to minimize the voltage drop in the cable."

(snip)

"I wonder how those modified Amiga power supplies would hold up when the load is very
heavy... when the user has added enhancements such as extra RAM, hard drive and CPU accelerator."

(snip)

"I use #16 wire in a 5' cable to feed a C128 and go to #14 for longer runs or to feed an Amiga which I know to be a power hog."

Back in California,
Robert Bernardo
Fresno Commodore User Group
http://www.dickestel.com/fcug.htm
July 29-30 Commodore Vegas Expo v13 -
http://www.portcommodore.com/commvex

[efrenmgp]

@tonyp12

Payment sent

Regards,
Efrén

[guibrush]

hy tonyp12

I'm interested into 2 pieces, thanks. The paypal payment is done. I live in Switzerland.

Thank you !

[tonyp12]

I should be able to start shipping some units tomorrow, half of the 15units have been sold now.

[guibrush]

Thank you !

[tonyp12]

I notice there is no on/off switch, so you have to unplug cord as off.
There is a green led to show power.

[LoadWB]

I notice there is no on/off switch, so you have to unplug cord as off.
There is a green led to show power.

These are handy for such instances.

https://ebay.com/itm/251523971634

[midway]

I would like one too pm sent.

Payment sent!

[wakido]

I'm definatelty interested.
Will send paypal soon.

Payment sent
Great work.

[tonyp12]

2 units left.

if  you need a power switch, putting a inline on the iec cord is an option, you should let ground/earth wire pass through uncut if possible

http://www.ebay.com/itm/WL-AC-110-250V-10A-Inline-ON-OFF-Table-Lamp-Desk-Light-Cord-Cable-Switch-Q-POP/282320975542?

In U.K. I think all outlets have a switch already.

[nyteschayde]

I'll take one. Money sent for shipping in the US

[kirk_m]

I'll take one.  PM sent.

[tonyp12]

OK, last two sold to the above two people.
I guess I need to engineer the 5pin Square connector from scratch, as that is stopping me for doing anymore units.

[kirk_m]

Payment sent.

[kirk_m]

OK, last two sold to the above two people.
I guess I need to engineer the 5pin Square connector from scratch, as that is stopping me for doing anymore units.

Ask Mech where he got his production run made when he was building power supplies a few years back.  I am pretty sure he didn't buy them off the shelf, and had to have them fabricated.