Amiga to PS2 mouse adapter

[curtis]

Don't know if anyone else has dealt with this fellow on ebay, but I picked up a couple and have to say they're quite nice and easy to assemble.  

Even works with USB to PS2 adapters.  At least the USB Micro$oft mouse I have worked.

Seller goes by the handle of kevmeister2003.

If you know which end of a soldering iron to hold, this is a pretty easy project.

Good price too.

Only thing I could ding it for is not being enclosed!

http://www.ebay.com/itm/111172915508

[NovaCoder]

Another option is the Micromys V4

Nice product but more expensive than DIY

[magnetic]

Sure the ms mouse will work as its based on the ps2 protocol. People are probably better off with micromys or cocolino since its professionaly done and has casing for a few bucks more. But for on a budget and for hobby solder diy guys that kit is fun.

[Coolhand]

Don't know if anyone else has dealt with this fellow on ebay, but I picked up a couple and have to say they're quite nice and easy to assemble.  

Even works with USB to PS2 adapters.  At least the USB Micro$oft mouse I have worked.

Seller goes by the handle of kevmeister2003.

If you know which end of a soldering iron to hold, this is a pretty easy project.

Good price too.

Only thing I could ding it for is not being enclosed!

http://www.ebay.com/itm/111172915508

Can't recommend Kevmeister enough.... I have that adapter, and the mk1 version, which came with an enclosure.  

you could always mod the mk2 to be more like the mk1, by removing the ps/2 connector and the 9 pin, and soldering leaded versions on.. then the whole thing could be easily enclosed in a small box or length of tube (like the barrel of a chunky pen perhaps) and end caps made to fit.

I also have a CD32 arcade stick interface board and one of his Amipad boards (fully CD32 compatible - it uses the same chips), which I modded into a PSX controller - I have a thread about it here: http://www.amiga.org/forums/showthread.php?t=66063