Welcome, Guest. Please login or register.
Forums
« previous next »
Pages: [1] 2   Go Down

Author Topic: A2000 CD-ROM with A2091  (Read 5956 times)

Description:

0 Members and 1 Guest are viewing this topic.

Offline Astra DanTopic starter

  • Newbie
  • *
  • Join Date: Feb 2011
  • Posts: 13
    • Show only replies by Astra Dan
A2000 CD-ROM with A2091
« on: March 01, 2011, 09:48:34 PM »
Hi guys.

I have an A2000 with a A2091 (with 2Mb fast RAM) running a 50M SCSI hard drive that boots to WB 2 quite nicely. I have had a 2x speed SCSI CD-ROM drive plugged in for years that's never been recognised by the system. I have just got hold of the A2091 Install disk, but not looked at it yet. I can transfer files and disk images from a PC to the A2000 using Amiga Explorer with no problems.

Basically, could someone explain as near step by step as possible how I would get the system to see the CD-ROM drive? Is it possible to get it to boot from it or does it always need drivers from inside WB first?

Many thanks for any replies.
Logged
A500+ 2 Meg
A500   1 Meg
A2000HD 3 Meg
A1200
CDTV x2
CD32 (Broken)
C64 SD2IEC
 

Offline actung_bab

  • Hero Member
  • *****
  • Join Date: Oct 2006
  • Posts: 650
    • Show only replies by actung_bab
Re: A2000 CD-ROM with A2091
« Reply #1 on: March 01, 2011, 10:22:56 PM »
Quote from: Astra Dan;618794
Hi guys.

I have an A2000 with a A2091 (with 2Mb fast RAM) running a 50M SCSI hard drive that boots to WB 2 quite nicely. I have had a 2x speed SCSI CD-ROM drive plugged in for years that's never been recognised by the system. I have just got hold of the A2091 Install disk, but not looked at it yet. I can transfer files and disk images from a PC to the A2000 using Amiga Explorer with no problems.

Basically, could someone explain as near step by step as possible how I would get the system to see the CD-ROM drive? Is it possible to get it to boot from it or does it always need drivers from inside WB first?

Many thanks for any replies.
well first of all got have it connected to power source then connected to scsi cable
set jumper id to number higher than your hard drive . have termintaion on if its the last physical scsi device on the chain.
boot your machine check to see if light on front scsi drive is flicking before the machine fully boots to wb should be slight delay .
download idefix97 of the aminet and run find device after you installed it fully to your hard drive
get back to me after these steps
Logged
Acthung baby
http://telnet://midnight-blue.dyndns.org
Cnet 4.60 PRO bbs software
Amiga 1200 020 14 mhz mbz 1200 z pcmcia network card 4 meg ram 2 Gb scandisk cf
Amiga 2000 020
Amiga 4000 030 25 mhz broken
Amiga x 4 1200
x 6 Sony Ps 3 Orginal 60 gb 4  port usb 160 gb hd (os 4.1 ready :-)
what can i say i like thse machines
x 3 XBOX 360 1x xbox 360 slim
url=http://avatars.jurko.net][/
 

Offline Astra DanTopic starter

  • Newbie
  • *
  • Join Date: Feb 2011
  • Posts: 13
    • Show only replies by Astra Dan
Re: A2000 CD-ROM with A2091
« Reply #2 on: March 01, 2011, 10:37:04 PM »
Thanks for that, I'll do that.
Forgot to say it's powered up, the access lights come on and it appears to spin the CD up when the Amiga is booting, but it's not visable in WB.
Logged
A500+ 2 Meg
A500   1 Meg
A2000HD 3 Meg
A1200
CDTV x2
CD32 (Broken)
C64 SD2IEC
 

Offline Matt_H

Re: A2000 CD-ROM with A2091
« Reply #3 on: March 01, 2011, 11:31:28 PM »
You need a CD Filesystem installed. Look for AsimCDFS, AmiCDFS, CacheCDFS, or BabelCDFS.

You won't be able to boot from CD.


EDIT:
@ Astra Dan

Thanks for catching that. It's my HAM post :)
« Last Edit: March 01, 2011, 11:37:57 PM by Matt_H »
Logged
 

Offline Astra DanTopic starter

  • Newbie
  • *
  • Join Date: Feb 2011
  • Posts: 13
    • Show only replies by Astra Dan
Re: A2000 CD-ROM with A2091
« Reply #4 on: March 01, 2011, 11:34:55 PM »
Thanks Matt. Hey look, your reply to me was your 4096th post. Kinda cool.
Logged
A500+ 2 Meg
A500   1 Meg
A2000HD 3 Meg
A1200
CDTV x2
CD32 (Broken)
C64 SD2IEC
 

Offline Tenacious

  • Hero Member
  • *****
  • Join Date: Jul 2002
  • Posts: 1362
    • Show only replies by Tenacious
Re: A2000 CD-ROM with A2091
« Reply #5 on: March 02, 2011, 12:04:50 AM »
Quote from: actung_bab;618807

download idefix97 of the aminet and run find device after you installed it fully to your hard drive
get back to me after these steps


How will he use idefix97?  This is a SCSI interface.  Does idefix97 improve SCSI?

@ Astra Dan

If you have OS 2.x, AmiCDFS might be your only free option.  It's on Aminet.

AsimCDFS is a little better (it handles long file names on Windows CD better) and comes with a CD player and Kodak PhotoCD ability.  It was (still is?) commercial software.  It can still be found on the web, too.

CacheCDFS comes with latter versions of the OS, but it always crashed my system.
Logged
 

Offline Astra DanTopic starter

  • Newbie
  • *
  • Join Date: Feb 2011
  • Posts: 13
    • Show only replies by Astra Dan
Re: A2000 CD-ROM with A2091
« Reply #6 on: March 02, 2011, 08:21:37 PM »
Thanks for that, gives me a couple of options.
Logged
A500+ 2 Meg
A500   1 Meg
A2000HD 3 Meg
A1200
CDTV x2
CD32 (Broken)
C64 SD2IEC
 

Offline Ral-Clan

  • Hero Member
  • *****
  • Join Date: Feb 2006
  • Posts: 1979
  • Country: ca
    • Show only replies by Ral-Clan
    • http://www3.sympatico.ca/clarke-santin/
Re: A2000 CD-ROM with A2091
« Reply #7 on: March 02, 2011, 10:26:16 PM »
Quote from: Astra Dan;618794
Hi guys.

I have an A2000 with a A2091 (with 2Mb fast RAM) running a 50M SCSI hard drive that boots to WB 2 quite nicely. I have had a 2x speed SCSI CD-ROM drive plugged in for years that's never been recognised by the system. I have just got hold of the A2091 Install disk, but not looked at it yet. I can transfer files and disk images from a PC to the A2000 using Amiga Explorer with no problems.

Basically, could someone explain as near step by step as possible how I would get the system to see the CD-ROM drive? Is it possible to get it to boot from it or does it always need drivers from inside WB first?

Many thanks for any replies.


Also, you need a later revision ROM chip on the A2091 for it to work with removable media devices, if I remember correctly.  You can usually find someone to sell you a revision 7.0 A2091 ROM here on Amiga.org or burn one for you for about $25.
Logged
Music I've made using Amigas and other retro-instruments: http://theovoids.bandcamp.com
 

Offline Astra DanTopic starter

  • Newbie
  • *
  • Join Date: Feb 2011
  • Posts: 13
    • Show only replies by Astra Dan
Re: A2000 CD-ROM with A2091
« Reply #8 on: March 02, 2011, 10:41:55 PM »
Oh do I? That's a pain. Thanks for the info.
Logged
A500+ 2 Meg
A500   1 Meg
A2000HD 3 Meg
A1200
CDTV x2
CD32 (Broken)
C64 SD2IEC
 

Offline Astra DanTopic starter

  • Newbie
  • *
  • Join Date: Feb 2011
  • Posts: 13
    • Show only replies by Astra Dan
Re: A2000 CD-ROM with A2091
« Reply #9 on: January 06, 2018, 01:43:08 PM »
Hi bit of a thread update. I have a Gotek drive I could hook up to the 2000 to transfer files.
Do I need a later revision ROM 7 in the A2091?

Thanks!
Logged
A500+ 2 Meg
A500   1 Meg
A2000HD 3 Meg
A1200
CDTV x2
CD32 (Broken)
C64 SD2IEC
 

Offline wlemonds

  • Full Member
  • ***
  • Join Date: Jul 2007
  • Posts: 112
    • Show only replies by wlemonds
Re: A2000 CD-ROM with A2091
« Reply #10 on: January 06, 2018, 02:41:47 PM »
Gotek is a floppy device and doesn't connect to the 2091 or any scsi controller.
« Last Edit: January 06, 2018, 03:04:53 PM by wlemonds »
Logged
A500 PAL ACA500 Plus/Gotek
A1200 060/66 Tower/Mediator
A2000 Vampire/4XEIDE\'99/MNT 2000/Ariadne II+
A3000 040/40
A4000 Tekmagic 060/50
X5000/20
 

Offline save2600

  • Hero Member
  • *****
  • Join Date: Jul 2006
  • Posts: 3261
  • Country: us
    • Show only replies by save2600
Re: A2000 CD-ROM with A2091
« Reply #11 on: January 07, 2018, 03:00:41 AM »
Quote from: ral-clan;619086
Also, you need a later revision ROM chip on the A2091 for it to work with removable media devices, if I remember correctly.  You can usually find someone to sell you a revision 7.0 A2091 ROM here on Amiga.org or burn one for you for about $25.

I'm using a SCSI CD-ROM drive just fine with my 6.6 ROM'd A2091...
Logged
 

Offline Oldsmobile_Mike

Re: A2000 CD-ROM with A2091
« Reply #12 on: January 07, 2018, 03:36:58 AM »
Quote from: save2600;834781
I'm using a SCSI CD-ROM drive just fine with my 6.6 ROM'd A2091...

This is a very old thread, but AFAIR 7.0 was required to use devices with LUN's (like SCSI card readers).  Mechy or someone like that would know for sure.  ;)
Logged
Amiga 500: 2MB Chip|16MB Fast|30MHz 68030+68882|3.9|Indivision ECS|GVP A500HD+|Mechware card reader + 8GB CF|Cocolino|SCSI DVD-RAM
Amiga 2000: 2MB Chip|136MB Fast|50MHz 68060|3.9|Indivision ECS + GVP Spectrum|Mechware card reader + 8GB CF|AD516|X-Surf 100|RapidRoad|Cocolino|SCSI CD-RW
 Amiga videos and other misc. stuff at https://www.youtube.com/CompTechMike/videos
 

Offline Astra DanTopic starter

  • Newbie
  • *
  • Join Date: Feb 2011
  • Posts: 13
    • Show only replies by Astra Dan
Re: A2000 CD-ROM with A2091
« Reply #13 on: January 07, 2018, 11:55:04 AM »
Quote from: wlemonds;834765
Gotek is a floppy device and doesn't connect to the 2091 or any scsi controller.

Sorry I meant I could use a gotek to get files from the internet onto the 2000.
Logged
A500+ 2 Meg
A500   1 Meg
A2000HD 3 Meg
A1200
CDTV x2
CD32 (Broken)
C64 SD2IEC
 

Offline Astra DanTopic starter

  • Newbie
  • *
  • Join Date: Feb 2011
  • Posts: 13
    • Show only replies by Astra Dan
Re: A2000 CD-ROM with A2091
« Reply #14 on: January 07, 2018, 11:55:38 AM »
Quote from: save2600;834781
I'm using a SCSI CD-ROM drive just fine with my 6.6 ROM'd A2091...


Could you tell me how you got it to work please? :)
Logged
A500+ 2 Meg
A500   1 Meg
A2000HD 3 Meg
A1200
CDTV x2
CD32 (Broken)
C64 SD2IEC
 
Pages: [1] 2   Go Up
« previous next »