Welcome, Guest. Please login or register.
Forums
« previous next »
Pages: [1]   Go Down

Author Topic: How do I format a HD under WB1.3?  (Read 1152 times)

Description:

0 Members and 1 Guest are viewing this topic.

Offline blakespotTopic starter

  • Hero Member
  • *****
  • Join Date: Dec 2003
  • Posts: 884
  • Country: us
  • Thanked: 8 times
  • Gender: Male
  • Visit ByteCellar.com
    • Show only replies by blakespot
    • ByteCellar - The Vintage Computing Blog
How do I format a HD under WB1.3?
« on: August 02, 2009, 11:07:06 PM »
Ok.  I have a StarBoard II w/ StarDrive SCSI controller on my A1000.  I've been piecing together the software.  I found the WB boot disk that the orig owner had, which refs stardrive.device in the mountlist in devs/.  Now - that mountlist is config'ed for another HD.  How do I...

1) Learn more about the HD I've got here?  Cylinders, etc.
2) Partition / format it under WB?

It seems that stardrive.device is in ROM as it's not on the boot floppy, but is ref'ed in the guy's mountlist.  I've got no StarDrive setup disk, sadly.  Must I have that to get this drive partitioned and formatted?

It's ~ 1GB HD.

Thanks.




blakespot
Logged
:: ByteCellar.com - The Vintage Computing Weblog
:: Amigas: 1000, 2000 '020, SAM440ep-Flex
 

Offline Matt_H

Re: How do I format a HD under WB1.3?
« Reply #1 on: August 03, 2009, 12:58:23 AM »
I don't know if the 1.3 version of HDToolbox allows you to work with devices other than scsi.device, but try grabbing it off a 2091 install disk and see if it does.
Logged
 

Offline Thomas

Re: How do I format a HD under WB1.3?
« Reply #2 on: August 03, 2009, 12:23:40 PM »
You could try this program: http://mitglied.lycos.de/thomasrapp/getgeometry.lha

It was written for a completely different purpose, but it will give you the required information to adjust the mountlist, if the driver supports querying the drive size.
Logged
 
Pages: [1]   Go Up
« previous next »