What's up with Hyperion's Website?

[Karlos]

I didn't create a swap until afterwards either, so I'm not sure that's the problem.

[cehofer]

Karlos, did you upgrade from 4.0 or do a new install with 4.1?  I'm going to install 4.0 again and try to upgrade it.  It is worth a try, eh?

[colin419]

I created an account two weeks ago and still have not recieved and email.  I try to log in and it says my account has not been activated and is disabled.  They do not have a support section that I could find to send them and email.

I even did the I forgot my username.  It said it was sending it to my email address and still nothing.

Hyperion, if you are watching, I need help with my account.

Yeah the same thing happened to me i signed up gave my details but got no activation email so i tried the same thing you did but still no luck.:confused:

[Darrin]

They are very busy working on Hyperion's most ambitious project to date, so expect delays.

What?  We're finally getting Civilization 2 for classic Amigas???!!!

[Karlos]

Karlos, did you upgrade from 4.0 or do a new install with 4.1?  I'm going to install 4.0 again and try to upgrade it.  It is worth a try, eh?

Nope, I installed it completely fresh. Still, your mileage may vary.

[cehofer]

I started from scratch and created a 2Gig partition for the swap drive before I re-installed 4.0.  I installed 4.0 no problem.  Then I made sure I upgraded to 4.1.  It appears that the Radeon 7000 is the issue because when 4.1 comes up it only has the P96-0:FakeNative:640x480/256 colors and none of the 9000 screen modes.  I am going to buy a 9000 Radeon card.

[NovaCoder]

They are very busy working on Hyperion's most ambitious project to date, so expect delays.

What's that, the final release of OS 4.1 for SAM users?

[Karlos]

I'll check more closely, but the radeon 7000 seems to work fine in my machine, even if I do have to turn the compositing off due to the lack of horsepower the card has.

[cehofer]

Update:  After I posted last, 4.1 was working fine just the resolution was VGA.  So last night I tried to boot it up and it did the same thing as it did when i started the thread and went to black with no disk activity.  So I rebooted with the reset button and the same thing.  So I walked away from it for a few minutes and when I came back 4.1 Workbench was on the screen.

I have ordered a Radeon 9200 256M and 1G of ram for it.  We will see how that goes once installed.