Author Topic: 3.9 and large hard disks (Read 1351 times)

Gavilan · « **on:** February 17, 2009, 04:38:57 PM »

I know this question has been asked many many times before, and i have been doing a lot of research before asking, but still got no answer at all so here i go:

I have a 2.5 80GB hard disk inside my machine.
I installed 3.9 from scratch. HDToolbox recognizes the disk as 74.9GB, so i assume everything is cool

I do a little partition ( 2GB) for System, put SFS, Boing Bag 1, 2 and reboot the machine.

When i go again to HDToolbox, and try to format and prepare the rest of the disk, i only find 26GB available. Its like if the hdd was 30GB capacity. Odd thing is that i can still see on the top of the screen that HDToolbox recognizes the disk as 74.9GB capacity

What am i doing wrong?? :-?
Am i missing something here??

Thanks in advance

Sebastian

Daedalus · « **Reply #1 on:** February 17, 2009, 05:29:48 PM »

Are you sure you have the latest versions of HDToolbox, FFS and scsi.device? Double-check them against the ones in the BoingBag 2 archive...

karel · « **Reply #2 on:** February 17, 2009, 06:21:39 PM »

Set block size to 2048.

Gavilan · « **Reply #3 on:** February 17, 2009, 06:38:59 PM »

Duh! I was using 512 which i tought was the correct block size for SFS partitions...damn!!

So thats my mistake?

I guess is time to re format all again and start once again from scratch?

lionstorm · « **Reply #4 on:** February 17, 2009, 07:46:42 PM »

you are right, SFS recommends using 512...

you will get no benefit in using a blocksize of 2048 except wasting space !

Author Topic: 3.9 and large hard disks (Read 1351 times)

Gavilan

3.9 and large hard disks

Daedalus

Re: 3.9 and large hard disks

karel

Re: 3.9 and large hard disks

Gavilan

Re: 3.9 and large hard disks

lionstorm

Re: 3.9 and large hard disks