Where is the PAL/NTSC jumper pad on a rev-5 A500?

[redrumloa]

As the title states, where is it? Aminet has a discription for rev 6.a but rev5 is different. Any idea?

[redrumloa]

Ok I am getting there. It is supposedly JP4, now I am looking for JP4:-)

[redrumloa]

Nope back to square one, JP4 is for a rev6.

[redrumloa]

I found the info I needed. Thanks! :-D

Boy that was easy:-D

[tonyw]

I'll bet you thought you had this thread all to yourself. Well, I've just spoiled your little game.

BWUHAHAHAHAHAHAHA

tony

[redrumloa]

@tonyw

:-P

Ok now tell me how I can tell the difference between pal and ntsc on a 1.3 system? I did the mod but I don't see the difference?

[Kronos]

@Red

Not sur what you are trying to do ?

Do you have old 512k Agnuses (sounds odd) ?
Those that came in Pal OR NTSC ?

Or do you want to change the default setting on a 1/2mb Agnus ?

Putting in a PAL-Agnus should do the trick in the first case, and in the 2nd you
would need to disconnect on pin which is on ground in NTSC systems.

(I could check that in detail if needed).

Also remeber that real PAL-Amigas only run at 7.09 instead of 7.14mhz  :-o

[redrumloa]

@Kronos

The A500 has a rev5 motherboard and an 8370 Agnes, this is a 512K version IIRC. From scouring the net for info it wasn't clear if I could do the hack with a 512K Agnes.

So basically you are saying the 512K Agnes is NTSC *OR* PAL? Gotcha, thanks :-/