No I don't have a big box Amiga only an A1200 Tower which I had a BlizzardPPC in and BVissionPPC card in with CGX4 but going by the documentation for CGX4 it sounds like it should work in 256 colour mode.
As I have never even seen a A2410 board I guess you will just have to give it a go yourself unless someone else jumps up to say they have one and have tried it.
Good luck with your project.
The only info I could find was the CGX4 Install Guide document which list the following requirements for CGX4:
Minimum requirements to run CyberGraphX4
o One of the following boards
- Picasso II(+) in linear mode (! not segmented !)
- Picasso IV
- Piccolo Z2/Z3 or Piccolo SD64
- GVP Spectrum
- RetinaZ3
- Wildfire Inferno
- CyberVision64
- CyberVision64/3D
- CyberVisionPPC oder BlizzardVisionPPC
- DraCo Altais
- Pixel64
- RainbowIII
- A2410 (*)
o Kickstart 3.x
o 68020 or higher
o 4 MB of fast memory
To guarantee work of CyberGraphX4 graphics extension , you have to
remove the old VillageTronic, EGS emulation, or Picasso96 software.
This is basically up to yourself. Only if you run CyberGraphX V2 before,
there is an uninstall script provided on this CD.
Remove tools like PatchDT or IPrefs2Fast to avoid conflicts.
(*) Partly Copyright 1995 Ignatios Souvatzis. All rights reserved.
Permission of distribution with the CGraphX system and necessary
modifications granted to Frank Mariak
