CompactFlash to IDE adapter for A1200 required

[jahc]

Where can I get a cheap one that can be shipped to New Zealand?

I had problems finding one in New Zealand that was keyed. The adapter I found didnt have the missing pin in the middle, so it wouldnt plug into my A1200's standard 2.5" ide cable. I didnt want to damage anything by removing the pin myself.

I've got a cheap 2gb CF memory card. I just need the adapter now. I'd rather just go for a cheap item, I dont care about performance.

I've seen a dual memory card adapter.. that would be kinda neat having the option for two drives/cards!

Also: I've heard someone mention that they need a hardware gayle fix to avoid spontaneous resets?? How bad is this problem? When does it occur?

Thats all for now.

[Computolio]

    You'll be fine if you remove the keying pin, as it shouldn't even be there in the first place. Just make sure you remove the right pin.

[jahc]

I wasnt confident I could remove it properly, or even get the right pin... so I sent it back and got a refund.

[jahc]

These look nice:
http://www.addonics.com/products/flash_memory_reader/ad44midecf.asp

Is $21 usd an alright price? I'll wait for your replies before I buy it (I'll try and wait anyway!).

[1985BMWK75]

Sent you a PM ;-) I believe that is a massive rip-off, especially considering the exchange rate of the NZD to the USD, which I imagine is even worse than the AUD :-(

Good luck ;-)

Nathan

[mongo]

http://www.dealextreme.com/details.dx/sku.10310

[AndyFC]

I was looking on ebay (UK) yesterday and found some ridiculously cheap ones:
This one is less than £2 including P&P and as it is from China, I can imagine you can get similarly cheap ones that will ship to you too.

[stefcep2]

I have that one and it works fine with one CF but I could never get it to work with a dual hard drive cable as slave master set up.

[Fingers]

Also: I've heard someone mention that they need a hardware gayle fix to avoid spontaneous resets?? How bad is this problem? When does it occur?

Try never! :-D

The fault you mention relates to PCMCIA, not IDE, so don't worry about it :-)

PZ.

[Fingers]

I could never get it to work with a dual hard drive cable as slave master set up.

They don't allow ANY other device to be recognized on the same bus...a total PITA, but it's unavoidable with a single cable setup.

I've tested maybe 5 different versions, all with the same problem you report.

Best just to grab a cheap buffered 4-way interface & be happy with a total of 3 IDE devices (or 2 fixed & 2 switchable if you get tricky ;-) ).

PZ.