CyberVision 64...

[Mauro73]

...and here I am again  :-D

can some one show me the right zorro slot to fit this video card into?
The computer is an A4000/040 desktop.

thank you in advance

Mauro

[Crumb]

It works in ALL zorroIII slots.

If you are using a Buster9 and your CV64 version is more or less modern perhaps you could try to change the CV64 jumper that switches from Buster11 to older Busters. I can't remember if it was JP1 or what...

[Mauro73]

Crumb wrote:
It works in ALL zorroIII slots.

If you are using a Buster9 and your CV64 version is more or less modern perhaps you could try to change the CV64 jumper that switches from Buster11 to older Busters. I can't remember if it was JP1 or what...

Thank you very much. My buster version is 11 so I think I'd have no problems at all  :-)

Mauro

[boing4000]

Is the card listed in Early Startup Control > Expansion Board Diagnistic?
Should be something like this:
1 8512 XX Working

I do have CV64-3D, dont know the procuct ID of CV64.

[zipper]

Phase5 is 8512; should be 8512/34

[Mauro73]

boing4000 wrote:
Is the card listed in Early Startup Control > Expansion Board Diagnistic?
Should be something like this:
1 8512 XX Working

I do have CV64-3D, dont know the procuct ID of CV64.

hummmm... I don't know, but I'll check it out today.

[Mauro73]

ok, I've checked:

Manufacturer: 8512
Product: 34
Status: Working

 :-)

[Mauro73]

Ok another question:

how do I connect the cables now? I mean vga cable from cv64 to a vga monitor and nothing else?

Do I have to connect the standard Amiga video port to an Amiga monitor too?

Or do I have to connect the standard Amiga video port to the CV64 through the vga adapter and then connect the cv64 to the vga monitor?

Any help would be wonderful  :-)

Thank you

Mauro

[Mauro73]

And once I've installed everything how do I change the screenmode to a 16million colors video mode?

thank you again

Mauro