One step closer actually I have had the Amiga booting. I think the problem was a conflict between my 2 IDE -> CF devices, I think both wanted to be masters... I solved that one, though my preferred device had to be slave.
The computer boots, no caps flashing, but I'm not there quite yet, because I have problems with the video signal from my Picasso IV card:
Most of the time when I boot (using a standard PC CRT monitor) I get a black screen, well I can see that the Amiga image on the screen is slightly less "black" than the surrounding. Once in a while, when I boot, I get a grey screen instead. It even booted and showed me a _very_ blurred WB screen. Also, once, I got a Guru screen which displayed perfectly. I checked with the monitor, when the screen was giving me the blurred wb screen it was at 31 KHz.... does this indicate that the scandoubler/flicker fixer is in trouble ??
Thanks to all of you for your help throughout this ordeal!!
Btw, I do, somewhere, have an Amiga -> Scart cable for the standard video output, but I am in the US and the TV I have access to does not have a scart plug but only the 3 plugs for Y, Pb and Pr.
The SCSI cable has starts at the external plug, then goes to the CSPPC board and ends at the SCSI CD-ROM.
Btw, I have 2 HD floppy drives in the Amiga, one FZ-357A and one FZ-357B drive, I have bought a new floppy cable from Amigakit, but I am unsure how to set the jumpers for drive selection... should both be DS0 or should one of them be DS1 ?? If one should be set to DS1, should it be the one before or after the "twist" on the floppy cable ??
