CD0: Unitialized?

[Dmaster]

Hello all, I finally got my A200T alive again, and it's been years since I actually used it.  I thought the power supply was dead, just needed cleaning

Anyhow, I had to replace the floppy drive with the one from my A500, the one it had could not read at all.

Now the machine boots fine but I keep getting a message on my workbench screen which says "CD0:Unitialized"  I cannot read any CD inserted to the unit at all.  Is there a way to fix this?  Thanks.

P.S. The last time I used it I was able to install OS 3.9 from CD just fine.

[rkauer]

 Click just one time in the CD0: icon on the devs:dosdrivers/ drawer.

 Then hold and press . It will bring you a window with the information of the icon.

 Look if your tooltype point to SCSI.device unit 1 (assuming the CD is the slave device in the IDE chain). And also check if your HD is set as Master (scsi.device unit 0).

[Dmaster]

Thanks alot, got it working!  

Next try wiping out everything and re-install OS 3.9 Fresh.

Hope it works!