A4000_Mad wrote:
PLAN A
1. Remove and discard CDrom drive.
2. Raise floppy drive to top holes in cradle.
3. The screw holes for hard drive will now line up perfectly.
Would the floppy drive line up with the faceplate then?
A4000_Mad wrote:
PLAN B
Replace 32mm thick floppy drive with 25mm thick floppy drive.
Wouldn't this leave a gap in the faceplate?
A4000_Mad wrote:
PLAN C
:egad:
:lol:
I think drilling holes might actually be a good option. *However*, I just put the drive in to the bottom bay wedged in temporarily so I could sort the cabling out, and irritatingly the clip on the bottom of the case which holds the drive housing in place prevents the hard drive from pushing back all the way! It sticks out so far that the faceplate of the A4000 wouldn't go on. The drive is so thick that there isn't enough space between the floppy drive and the hard drive to move the hard drive up any further to make it clear the clip.
I suppose I could bend the clip down, but I don't really want to since there would be nothing holding the drive chassis in place other than the two screws at the front.
--
moto