Micronik Z-3i Mk2 (6860 rev6.6 - 6.8) jumper settings

[Hodgkinson]

Hi there,
I have a A1200T with a Micronik Z-3i Mk2 (6860 rev6.6 - 6. busboard installed. Unfortunatly, I have sinced removed the '030 card from the system (In order to build up another A1200) and the system will no longer boot.
Apparently, there are jumpers that determine wether the A4000 processor slot, A1200 accelerator, or the motherboard 68020 is used.

Does anyone have a manual or jumper information for this busboard?

Thanks,
Hodgkinson.

[Painkiller]

Will this help?

http://amiga.resource.cx/photos/micronik1200z3

Aaa here is the manual:

http://www.amiga-hardware.com/downloads/busboardz3-66_e.lha

[Hodgkinson]

Thats the board...I've downloaded the manual but for some reason I can't quite see how you managed to find the manual in the first place...
(I assume the manual is for the v6.6 to v6.8 boards, SCSI, no RAM?)

Thanks,
Hodgkinson.

[Gwion]

Is that the board that was on ebay recently?

[Hodgkinson]

Is that the board that was on ebay recently?

 :roll: I haven't looked on ebay in ages. The actual board that I have was mounted in a Micronik tower that I was given a while back.

Hodgkinson.