ShapeShifter FileTask error

[Damion]

When I go to start ShapeShifter on my A1200/060/OS3.9 setup, I'm getting the following error:

ShapeShifter FileTask
Program failed (error #80000003).

I get the initial Mac screen, then as soon as it begins to load (right when the little mac icon appears) it crashes.

Yet, it works fine if I run ShapeShifter from my clean 3.1 install (same SS config).

I've tried just about everything I can think of, including comparing SnoopDos logs, swapping libs around, disabling this, that, and etc.

I keep thinking I must be overlooking something simple.

Any ideas?
 
BTW -- There was an exact replica of this topic circa 2003, yet I can't access the thread for some reason.

[Damion]

Hmmm, works if I run ShapeShifter from shell.

DOH! A tooltype issue. Fixed. (LOL, knew I must have been overlooking the obvious..:crazy:)

[dh1]

Damion, I'm seeing the same issue here, but under AmigaOS 3.2.2.1.
And you're right — it works if I launch ShapeShifter from the Shell!
What did you change in the ToolTypes to get it working on your system?
THX!