SimStation Resurrection II: VERY CLOSE! Need just a bit of help!

[Mallette]

Hate to think how many hours into this, but getting very close.  

I've managed to copy the SimStation files to a new disk and get it to boot.  The only problem is I cannot seem to get the Work1 and Work2 partitions to show up.  The startup-sequence is working and calling for them, but they just don't show.

Is this a mountlist issue or what?  I made 3 2gb partitions on the disk, Workbench, Work1, and Work2.  They all show fine in WinUAE, but the A4000 doesn't mount or see them.  

Another thing I found out (amongst many) is that the drive wasn't seen at all until I put a jumper in to limit it to 32gb (it is an 80).  Small things...

Any thoughts?  Sooooooooooo close!
Dave

[jj]

Unless you have certain patches installed, or are running 0s3.9 I believe you are suffering because the miggy will not reconise anythin over 4GB.  so the partions will not be visible.

Winuae has built in support for bigger drives

[Jose]

If you're using AmigaOS3.1 and your HD is bigger than 4Gb you need either IDEFix, NSDPatch, or AmigaOS3.5/3.9
Never tried NSDPatch myself, generaly IDEFix is what most people use with 3.1.

[Mallette]

Are we talking TOTAL or per partition?  All three partitions are 2gb.

Dave

[Jose]

Total.
And even after installing above mentioned software, boot partition should allways be less than 4gb, 2gb to be safe IIRC.