MUI Installing problem

[Kin-Hell]

Hi folks! Got a spot of bother trying to Install MUI. Miggy is an A4KT with PPC604e. I had to re-Install for trashing my 18Gb Drive. (Another thread)

Fortunately, I had just Prepped another 8Gb Barracuda on the PPCSCSI, so I used the OS3.9 Boot Disk & Installed OS3.9 & Installed Boing Bags 1 & 2. After this, I got all the Mediator Drivers on; Voodoo 5500 all setup; Ethernet drivers on; & then faced "MUI".

I needed to get MUI on so I could Install Miami & get the Internet all setup with iBrowse. (also needs MUI) When running the Install, I get this Error in the "Install Process GUI":

Sorry an Error has Occured!

COPYLIB: Can`t open file " " in line 299
DOS Error Type: Unable to locate a file or drawer

There is a Proceed Gadget at the bottom of the Install Process GUI & obviously quits the Installer & doesn't install MUI.

I installed 3.1 on another partition, only installed the 040 & 060 Libs & then ran MUI Install again! Ironically, it gave the same Error! :-?

Anyone got any suggestions please?

 

[doctorq]

If you extracted the MUI archive with UnARC, this might be the reason for your problems, as it have problems with files without characters. Use LHA.run from Aminet to get a working LHA extraction tool, and extract the archive again. You should be able to install without problems now, both on OS3.1 and 3.9.

[countzero]

you have to extract mui once more from the archive if you already installed it once. mui install deletes a file when it has been installed once, you can't reinstall until you re-unzip it from the archive.

[Kin-Hell]

Absolutely "Spot On" doctorq. Thanks ever so much!  :-)