No Manual, whose's is that in the pic?
Oh, well...there are other threads- see (which pin on gary for dkb multistart ii)
with all the info.
I think the manual is the property of Lex. (Hopefully Lex will see this and share his information)
I've looked at all of the other threads that I can find here. I am actually the one who started the "which pin on gary for dkb multistart ii" thread. The problem is that none of the threads explain what all of the jumpers do and how to set them for various configurations.
Apparently there were also a couple of different versions of the MultiStart II board. Some had a ribbon cable and others had pins that plug directly into the ROM socket so that the board actually sits just above the ROM socket.
Mine does not have the ribbon cable and has three different jumpers on the board.
When looking at the board with the wire for the Gary chip in the upper right corner.
1. A two position jumper (three pins) - Located just to the right of the 74HC74 on the top of the board. I believe that this is the one that is set depending on the machine type.
2. A two position jumper (three pins) - located to the right of the right most ROM socket and towards the bottom of the board. I believe this might select the default boot ROM.
3. A single position jumper (two pins) - Also located to the right of the right most ROM socket and towards the top of the board. Don't have a clue what this one does.
Regards,
AmigaEd
