PAL booter on bootblock?

[TjLaZer]

Is there a tool that will write code to the boot block to boot to PAL?  There is "SwitchInstall" on aminet which works great..On WB 1.x !  But NOT on WB 2.x onward.  If I could program I would write such a tool...  I like SwitchInstall but do not know why it does not work on later WBs.

[kidkoala]

when i looked long enough on your flamed bananas..they stopped dancing!? (only the flamed ones)

[ptek]

@kidkoala :

It's the power of your mind

:-)

[kidkoala]

..says the guy that's convinced onions have layers!?

)

[InTheSand]

Hi,

Have you had a look at Kill2090? This will allow you to reboot the Amiga and force it into either PAL or NTSC.

Or Hackpics for how to make a hardware modification to do this.

Or HZ for a very small assembler program to do this (with source) and TINYpalntsc that does the same thing. Perhaps one of these could be included in a bootblock?

 - Ali

[kidkoala]

I think all the software-hacks only makes it possible to use pal in wb-screens?

[Ilwrath]

No.... He's looking for a bootblock you can install on floppies so that you have a boot-time PAL/NTSC option.  I had two...  One of which I think was the "SwitchInstall" (which I don't remember NOT working on WB 2, but I'll assume that's correct) and the other was always detected as a Virus by several scanners (though it never seemed to harm the disk it was installed on -- just turn off the computer after you were done with it!  :lol:  )  

I really wish I could remember what the last one was called, and if I ever got either of them to work with WB 2.x.   Of course, thinking about it for a second.... Would you really need a bootblock switcher?  For WB 2+, couldn't you just replace the NTSC monitor device with a PAL one, if you have ECS Agnus?