Vulture wrote:
Doppie: that pic might help me a bit with the wires thing, but mine are not colored, they're both blue....It's better than nothing tho...Now, if u manage to give me some more info at some point about that and where the chips should be clipped I'd be eternally gratefull! From the photo I half-understand that sd clips on Lisa and ff on Alice....is that right?
That's right. The main board (the one with lots of components) goes on top of the Lisa chip. The connector for the flat cable faces to the back of the Amiga.
The other board, from where the two wires come from goes on top of the Alice chip.
If you pay attention to the Doppie picture, you can see that the red wire is on the right hole on the Alice board, and in the bottom hole in the Lisa board.
If you put your wires the same way, everything should be fine.
Anyway, these two wires takes the H and V sync signals to the main board. If you connect them reversed, all that will happen is a malformed, or no picture at all. If this happens, just reverse the wires and you should be fine. You'll not damage your Scandoubler if the wires are reversed.
