A3000T Fast Slot not working HELP!!!

[TjLaZer]

OK my A3000T has an issue.  It was working fine but stopped working so I eventually opened it up to see what the problem was.  I had to do this a few times before, it was an easy fix.  Reinsert the CPU card (A Phase 5 MKII 060) and it would work.  Well this time no juice.  I removed the card and it booted right up to 030 mode.  Suspecting the card I installed it in a A4000D and it worked fine.  Hmm I then tried the A3640 in the A3000T.  Nothing.  Then found out I need a chip:  74F08.  Ordered it and installed it no go.  Found the jumper setting on google so I have them correct.  

J100  3-4
J102  2-3
J104  2-3
J105  1-2
J106  1-2
J107  1-2

I did have a slightly leaky batt when I first got it and removed it right away and did the Lithium hack.  Then later it was dead and found 1 bad trace and repaired it and she came back up.  Been like 2 years since then.  Could it be another trace bad now?  (For fast slot)?  I am stumped as it works in 030 mode fine.

[amiga92570]

A3000 tower jumpers for a3640 should be

j100 3-4
j102 2-3
j103 1-2
j104 2-3
j105 2-3
j106 2-3
j107 2-3

If jumpers are set for a3640, or cyberstorm the on board processor will not boot with accelerator unplugged. I would highly recommend you do not ever change J105, j106, j107. Things can be ruined.  :-o

[TjLaZer]

To use the A3640 I had to install the chip 74F08 that is why I set the J105, J106, J107.

[rkauer]

Looks like a broken lid on the CPU connector. If you have a dead A3000 (or even 2k or 4k), take the connector from and replace it (you'll need some ironwork).......

 :rtfm:

[alexh]

Some Usenet posts also have different settings to yourself

The jumper settings that actually made the MKII work in my A3000T/040 are these:

J100  1-2
J102  2-3
J104  1-2
J105  1-2
J106  1-2
J107  1-2

[dannyp1]

I have just been going through the same problems as this thread describes.  I couldn't get a Cyberstorm MKII to work in an A3000T 040.  The A3640 worked fine, but the MKII did nothing. It took me awhile and a lot of testing but I finally got it to work today.  I put a 74F08 chip in U103 which was empty.  This alone did nothing.  I then changed J100, and J104 and presto, the computer tried to boot.  I then mounted the new libraries for the MKII and rebooted and I finally had it working.  Now for my question.  I did nothing with the J105, J106, & J107 jumpers.  They had no jumpers on them and still don't.  I have read here and several other places that all three should be jumpered on pins 1-2.  There is also a post earlier in this thread that says they should all be jumpered on 2-3 and never changed.  Could someone give me some help with this?  Is it fine like I have it with no jumpers at all (which is how the computer already was), or put jumpers on all 3 and what pins should I jumper?  By the way, I changed J100 to 1-2 and J104 to 1-2.   Thanks,

Dan