Cybervision 64 on A4000 Desktop

[swordfish]

I posted a question yesterday on the forums related to finding a driver for my phase 5 Cybervision card. As yet i have only been unsucessful, my A4000 is using an 040 processor and talking to someone yesterday suggested that maybe my revision of my Motherboard was Rev9, im not sure about this, but would really like to be able to use this graphics card i have sitting here. If anyone out there uses this card, its not the 3D card but the Cybervision 64, could they please tell me what drivers they use or how to go about installing them and what tooltypes they have used? I have tried installing many drivers only to get an error of #80000004 cybervision failed and it points to the driver in the Devs:Monitors folder?

Any ideas please?

[swordfish]

I have also tried the latest picasso96 drivers.

[melott]

Hmmm..... the Picasso drivers should work.
I have a CV64 card in my A3000 /WarpEngine 040 and
the CV64 drivers and the Picasso drivers work in my
machine. Its just a matter of preference.
I'm sure its something you don't want to think about
but maybe the card is bad.
Wish I could be of more help.

[swordfish]

I've been told the card works on an A3000 but i've got no A3000 to test this on - I'm wondering if maybe i'm using the buster 9 chip that is causing problems? I've got another A4000 coming soon so will test it on that also, it uses the buster 11 chip.

[Brian]

Buster revision shouldn't matter when it comes to CV64, I'm pritty sure my old A4000 with CV64 had Buster9.

[aggro_mix]

There's a jumper on the CV64 board, it should be open with rev. 11 Buster and closed with rev. 7 or 9 Buster. According to the manual it's only usefull with CV64 boards with seriealnumber 81xxx

[Framiga]

Hi swordfish

with CV64 and SB9, you must set the JP1 "Slow Buster Mode" jumper.

Take a look Cybervision64 jumpers location

Bye

NOTE . . .argh!!!- if your not able to log at the link, goto:

http://xoomer.virgilio.it/cieffeeditingvideo/pic

Cybervision64.jpg

EDIT- post which accelerator card and OS you have and check again if you haven't mixed CGX and P96 stuff in libs:

[patapom]

Hi everybody,

Please help me, I have the same issue
I'm trying to bring back life to my old amiga 4030...

I've upgraded the cpu to warpengine 040@40, roms 3.1 & wb3.9, ariadne 2, scandoubler & a cybervision 64...

unfortunately, when I install the cybervision 2, and activate the resolution to 640x480x24bits my amiga is crashing
My motherboard is built with a buster 9, and I tried with & without the jumper closed: same result

[Robert17]

I had a similar problem when I was setting up my Prometheus, make sure you have the latest relevant Libraries, 68060 for me, I think there's 68040 libraries too, never had to use them though.

Robert

[patapom]

can you help me to get the latest version?
I installed the v2 given with the card   :-?

can it be a buster issue?