Author Topic: Hypertec PCMCIA Network Card (Read 1481 times)

Twin · « **on:** August 31, 2004, 02:35:23 PM »

I bought a Hypertec Hypernet PCMCIA network card off Ebay to use in my A1200/030. It is listed in the cnet.device compatibility list in the part ripped from the Linux list so I took a gamble.

I was really looking forward to getting this working but:

Trying to configure it using miami I get an error message

CISTPL_CONF_MAP tuple not found

and I cant get card_info to recognise it either. I think I have cardreset and everything working properly. I assume its not compatible, any suggestions?

Linchpin · « **Reply #1 on:** August 31, 2004, 02:56:20 PM »

Tried resetting it by removing / readding the card?

Twin · « **Reply #2 on:** August 31, 2004, 03:12:39 PM »

Ive tried removing it while the computer is on, booting with it out then putting it in while it is on etc

Still no luck.

adolescent · « **Reply #3 on:** August 31, 2004, 05:31:33 PM »

Are you sure the card is functioning? (ie. try it in a PC?).

Twin · « **Reply #4 on:** September 03, 2004, 02:32:26 AM »

Yeah I tried it in a laptop PC and it worked fine.

Ive also installed WB 3.1 (as suggested on AmigaWorld.net) and still get the same error message.

PiR · « **Reply #5 on:** September 03, 2004, 11:20:59 AM »

Have you chacked it with 'prepcard' or whatever is the name of this tool in the system?

Twin · « **Reply #6 on:** September 03, 2004, 02:46:11 PM »

Yeah it gives me a "memory attribute" error

Author Topic: Hypertec PCMCIA Network Card (Read 1481 times)

Twin

Hypertec PCMCIA Network Card

Linchpin

Re: Hypertec PCMCIA Network Card

Twin

Re: Hypertec PCMCIA Network Card

adolescent

Re: Hypertec PCMCIA Network Card

Twin

Re: Hypertec PCMCIA Network Card

PiR

Re: Hypertec PCMCIA Network Card

Twin

Re: Hypertec PCMCIA Network Card