Author Topic: ADF2Disk Issue (Read 1412 times)

DeltaWolf7 · « **on:** July 08, 2004, 07:52:43 PM »

Hi, I have just made a disk out of a adf image of some pd software, i transfered the image via serial to my a1200.
I used adfblitzer and all went well the first time.
The game booted and was perfect.

Now I tried today to do the same thing with another game and when adfblitzer gets to about 50% it stops saying no disk in df0.

Does anyone know why this is happening? I have even tried the original image i did the first time but i cant even get that to write.

Also I am using PC disks with sticky tape over one of the holes, which I have not had a problem with until now.

TheMagicM · « **Reply #1 on:** July 08, 2004, 08:05:22 PM »

does that happen only w/adf2disk? or anything? ie. formatting a Amiga floppy, or just plain copying a ADOS disk? Could it be your drive is messed up? tape came off and is stuck in there?

DeltaWolf7 · « **Reply #2 on:** July 08, 2004, 08:09:50 PM »

The disk and drive are fine, i can access a formatted disk, or access any other disk fine, copy, rename, use tools, etc the problem only occures with adf2disk and adfblitzer.

everything else is fine as far as i can tell.

Crusher · « **Reply #3 on:** July 08, 2004, 09:37:23 PM »

Get snoopdos and look what happens. :-)

DeltaWolf7 · « **Reply #4 on:** July 08, 2004, 10:51:56 PM »

snoopdos says all is ok, i cant belive this but now its ok again, i just managed to put the game back on to disk.
It must be a have to try again work around...

Author Topic: ADF2Disk Issue (Read 1412 times)

DeltaWolf7

ADF2Disk Issue

TheMagicM

Re: ADF2Disk Issue

DeltaWolf7

Re: ADF2Disk Issue

Crusher

Re: ADF2Disk Issue

DeltaWolf7

Re: ADF2Disk Issue