Welcome, Guest. Please login or register.
Forums
« previous next »
Pages: [1]   Go Down

Author Topic: A2286AT and floppy drives.  (Read 1005 times)

Description:

0 Members and 1 Guest are viewing this topic.

Offline flaviosrTopic starter

  • Sr. Member
  • ****
  • Join Date: Jan 2007
  • Posts: 321
    • Show only replies by flaviosr
    • http://www.facebook.com/flaviosr
A2286AT and floppy drives.
« on: August 26, 2007, 01:50:16 AM »
Hi to all,

I have mounted my lovely A2286AT with two floppy drives: one 3 1/2 and one 5 1/4.
The card refuse to start from the 3 1/2 drive if the 5 1/4 is installed (the drive! Not a floppy in the drive)... and I do not have any 5 1/4 floppy for further tests! :(
If I disconnect the 5 1/4 drive everything is ok and the card boots from the 3 1/2 drive.
Is this normal? Some jumper to set? I have tried all the possible combination in cable mouting and setup configurations...

Ciao and thank you
Logged
A500 +A600 +A1000 +A1200 +CDTV
A500 +K3.0 +Viper520CD +
A1200T +K3.1 +Blizzard 603+ (240/50) +
A1200T +K3.1 +Blizzard 1240/40 +
A1200 +K3.1 +Blizzard 1230/50+CoPro +
A2000 +K3.1 +A2630 +
A3000 +K3.1 +Cyberstorm MkIII +
A4000 +K3.1 +A3630 +
A4000T +K3.1 +A3640 +
 

Offline murple

  • Hero Member
  • *****
  • Join Date: Jul 2007
  • Posts: 579
    • Show only replies by murple
    • http://www.murple.net
Re: A2286AT and floppy drives.
« Reply #1 on: August 26, 2007, 02:32:22 AM »
Floppy drive cables have to be hooked up in a certain order. See the ribbon twist between the 2 drive connectors? The first (boot) and second floppy have to be on the right connectors. Try to swap them and see if that helps.
Logged
 

Offline Matt_H

Re: A2286AT and floppy drives.
« Reply #2 on: August 26, 2007, 02:35:45 AM »
I think the board itself also needs to be jumpered in a certain way if two drives are connected. The Janus software also requires some configuration.
Logged
 
Pages: [1]   Go Up
« previous next »