FS: Amiga500 Amiga1200 PowerSupply New Replacement. $29.95

[kirk_m]

OK, last two sold to the above two people.
I guess I need to engineer the 5pin Square connector from scratch, as that is stopping me for doing anymore units.

Ask Mech where he got his production run made when he was building power supplies a few years back.  I am pretty sure he didn't buy them off the shelf, and had to have them fabricated.

[Acill]

Ask Mech where he got his production run made when he was building power supplies a few years back.  I am pretty sure he didn't buy them off the shelf, and had to have them fabricated.

I looked into doing it and it's not cost effective to do them and still be able to sell a new PSU at a reasonable price to make up for the manufacture cost. The better idea is to find an existing part to solder into a custom board that can be solder in place of current o e, but you need someone like me that can install it on top of that in order to use  it.

[LoadWB]

Received mine.  Very nice piece of work, thank you.  One huge benefit over the APower ones I have (which I also like, very much, don't get me wrong) is a longer Amiga-side power cord.

[midway]

got mine. Doesnt power on. :confused:

Did you test it before sending it ?

[tonyp12]

I load test them and measure the voltages on all pins just before I mail them out.
Can you test with another eic cord/outlet?
Could gone bad after I test it, if so mail it back.

[midway]

It was the power cable!  Thanks for sending me another:)

[tonyp12]

In two weeks I will start selling Amiga1200 power right angle ADAPTER with same PowerSupply.

As the A500 don't have its power connector on the far end, this adapter will not fit.

This A1200 adapter will have a 4pin molex output and use machined pins to "emulate" the square din connector.

Maybe make a A500 version later.

[wakido]

Mine arrived (AUSTRALIA), haven't had a chance to check it out properly...
hopefully on the weekend...
Cheers

[efrenmgp]

Received mine last friday. Tested and working fine

Thanks!