where to gin 44 pin IDE passthrough connector?

[klx300r]

my IDE connector on my 1200 MB lost 7 pins when I took off the existing IDE cable recently..arghhh....I want to solder in a new one on the MB..any one know where I can get one?

[Drac]

Go to your local recycling center and look for a used computer to desolder it from.

Cheap and easy

[Daedalus]

You'd be hard pushed to find a used computer with those smaller pins on it - they're rarely used these days. Maybe have a look for a dead A1200 or A600 to take some pins off...

[tone007]

Here's a nice clean new one if you don't feel like just replacing the few pins. http://cgi.ebay.com/44-Pin-2-0-Pitch-Polarized-Shrouded-Male-Header_W0QQitemZ150360790363

I'd probably just do the few pins, myself.

[amigakit]

We can supply the full pin header with correct pitch for resoldering to the board.

[klx300r]

You'd be hard pushed to find a used computer with those smaller pins on it - they're rarely used these days. Maybe have a look for a dead A1200 or A600 to take some pins off...

I wish i could! In my parts 600's and especially 1200's are extremely hard to come by....

[klx300r]

Here's a nice clean new one if you don't feel like just replacing the few pins. http://cgi.ebay.com/44-Pin-2-0-Pitch-Polarized-Shrouded-Male-Header_W0QQitemZ150360790363

I'd probably just do the few pins, myself.

thanks for the link tone! I was thinking of just putting the loose pins back but then I thought if I was going to get the soldering kit out yet again I might as well do the full job right the first time! of course this thinking took me many many a year to grasp :-)

We can supply the full pin header with correct pitch for resoldering to the board.

PM sent :-) If the postage doesnt kill me I'd rather buy from you guys as Ive always been happy with your service :-)

[Jope]

Like said, don't unsolder everything. Just clean the holes for the broken pins and solder them in one by one.