Masoboshi SCSI/IDE MasterCard (MC-702) problem

[aquapuls]

If Autoboot on:
1. computer will not boot (black screen)

If Autoboot off:
1. computer start
2. sysinfo is visible the board and added memory
3. but there is no in hdtool masoboshi.device
 
Any ideas?

[aquapuls]

does the memory string up ok?
 
what mass storage are you using SCSI or IDE ?

I tested both IDE, and SCSI HDD.
In the Autoboot computer will not start.

When Autoboot off, the computer starts, but no in HDTool masoboshi.device. Memory is added.

[aquapuls]

In HDToolbox did you change the SCSI_DEVICE_NAME?
 
You should changed it into something like SCSI_DEVICE_NAME=MASOBOSHI.device in order to see it.

I'm using OS3.9 and do not understand how to change SCSI.device in HDTool ?

[aquapuls]

What kind of disc do you use? Does the problem also occur without disc?

Without HDD same problem.

[aquapuls]

1. Select the HDToolBox icon
2. Press right mouse button and select Icons -> Information... from the Workbench menu
3. Change/add tool type SCSI_DEVICE_NAME=MASOBOSHI.device
4. Save the settings
5. Start HDToolBox

Thank you.
I did as instructed.
But masoboshi.device not in HDTool, only scsi.device

[aquapuls]

If Autoboot on (jumper on):
1. computer will not boot (black screen)

[aquapuls]

If Autoboot off (jumper off):
1. computer start
2. sysinfo is visible the board and added memory
3. but there is no in hdtool masoboshi.device
 
It seems to me, the on board is not the original ROM (I bought board at the Ebay).
Any ideas?

[aquapuls]

Well, http://web.archive.org/web/20130406091703/http://amiga.resource.cx/exp/mastercard

Why closed amiga.resource.cx?

[aquapuls]

Well found and caught sir!
 
 
I have found the ROM file, its 17.5k which is quite interesting as this means one requires a 32k chip -
 
 
@Aquapuls
I have a few chips so if you would like, just send me a PM of your address and I will post you a programmed chip - I will get you a postage quote it should be quite cheap.
 
If you have the kit at home to program these then you will need a 27c256 @ 200ns (or lower) you will need to "pad" the end with "00"'s or "FF"'s I would recommend the latter.
 
Alternatively one could use a EEPROM W27E257 (Winbond 32k)

Dear @Zetr0,
Thank you.
Unfortunately I do not have a device for programming EPROM.
I'm willing to pay you for a ready-ROM (EPROM) with V2.202 (including shipping), if possible.

[aquapuls]

EPROM V2.202 for Masoboshi card arrived.
It works perfectly.
Thank you very much for @Zetr0.