Bvision Problem - Missing connector

[Karlos]

The connector sure doesn't look anything special here. Just an 10 pin IDC connector, sheilded ribbon cable going to a VGA connector.

Im sure there'll be a schematic online somewhere.

I do have a dead bvision - but unfortunately I don't have a spare ribbon (my working bvision is using it).

-edit-

Corrected number of pins ;-)

[Karlos]

Aww, bugger - no camera, unfortunatley :-(

I can't see (looking at it) that there are any additional components on the VGA connector end, just the ribbon attaching to the VGA socket. So I guess the only trick is to make sure the correct pins in the VGA socket are matched up with the BVision connector end.

There must be a few people with dead bvisions (as already said) who can donate a cable...

[Karlos]

Framiga wrote:
Hi Jaruzel

i have here the one of the CVPPC and it seems the same.

It is not so easy to built a new one.

It has 3 transistors (VGA part only) and theyrs capacitor, resistor for RGB analogic output all micro SMD.

That's strange. There are no additional components of any kind on my BVision VGA connector that I can see.

[Karlos]

Framiga wrote:
@ Karlos

so the above posted picture is wrong.

Perhaps there are different revisions. I just opened my system and examined the cable. No components other than the cable connector on a tiny PCB that simply attaches it to the VGA on a backplane. Nothing else.

EDIT- if the cable hasn't additional component, it isn't a great problem to make one.

No picture needed but only pins assignment.

Pretty much what I was thinking ;-)

-edit-

Incidentally it's a 10-way IDC connector - not an 8-way one like I said earlier ;-)