Accessing CSPPC bootmenu from WB?

[elendil]

Huya,

Is there some way to change scsi config of the CSPPC from workbench?

My problem is that I need the CSPPC to NOT scan for a specific unit, and in turn scan for another, and my rgb out on the a4k is partly broken.
Said differently, I'd like unit 2 to be scanned and mounted automatically, and unit 0 to stay powered off, until I need it (it's very, very noisy).

Sincerely,

-Kenneth Straarup.

[elendil]

Hi, no I don't have one of those graphics boards (but a cv64).

Unitcontrol can both rescan the chain (finding the disabled units too), mount, unmount and power down units. You can also change scsi configs for each drive, but not what's enabled and what's not, sadly (unless there's a new version I don't know about).

Thanks for the replies, though.

Sincerely,

-Kenneth Straarup.