Mediator/Voodoo 3 issues

[Acill]

Not that I have any real problems with my system, but I could use some help.

When I set up my Mediator on the A3000 I used all the default setting to get the voodoo 3 working. I heard this isnt ideal, but can never figure out hoe to get better ranges of display modes set up in P96. Every time I fool with it I get freq out of range on my monitor. As I now I have a great looking 800 x 600 display and a slight flicker in 1024 x 768. Its because the vertical frew is only 62HZ I am sure.

Here is what I need. Can anyone using a voodoo 3 and mediator send me the files for the settings so I can try to use them and see if it helps any? PM me for info to send them.

[Acill]

Yes I know, but thats the problem. I havent been able to ind any information on this monitor at all on the net, and I have looked all over the place too. Its a DigiView HR-55 15" monitor. The problem is DigiView is no longer in business as far as I can tell.

[Acill]

I just found this information on the DigiView HR-50, which I am sure has the same specs as mine does since the next one after mine is also the same specs as this one. I hope you can give me a guide to the proper P96 setup for this darn thing at last!!!

DigiView HR-50
Dot Pitch .28
Max Res 1024X769
(H)30-50khz (V)47-104hz
Price $147

[Acill]

So I assume when I run the install P96 setup and it asks for my monitors max rate I would enter the closest to 50 it offers correct? If so then I am set up as best I can get. Thanks