No Display on my A3000

[Bonami]

Hi, from what you wrote, you have three choices of display namely (i) amiga video 23pin (ii) amber VGA (iii) VGA from GVP card (is it IV24?). You sure you've tried all?

The transformer should be no problem (it should be 250V->125V not 250W->125W), since you heard the hdd spinning up.

Also, on the mobo there's a jumper for selecting PAL/ NTSC. Have you tried that?

The last but unfortunate possibility is that the dishonest seller had ripped you off by selling you an a3000 with faulty display ... :-(

[Bonami]

Hi, my A3000 is of rev 9, with the pal/ntsc jumper located next to the Fat Agnus chip, towards front panel. The 'PAL','NTSC' are actually labelled there.
Check if your GVP card has pal/ntsc jumper too?

Here in Singapore we're using PAL for TV & video. How about in ozziland?

[Bonami]

Any luck by swapping the CIA chips?