FastlaneZ3 can't read drive geometry

[Markus_Bieler]

I installed a FastlaneZ3 but the controller can't read the geometry of all connected drives.

The rampart works with a charm.

My config:

A4000D + Scandobler +  GVP Spectrum + Ariadne + FastlaneZ3

Kick 3.1

Markus

[Markus_Bieler]

A4000D + Fastlane (40mb fastmem) + GVP-Spectrum + Scandoubler arXon + Ariadne

kick 3.1 + os3.1 plain on IDE-harddisk

HD-Toolbox has same problem. Recognises that there is something on the bus, but not what drive.

Markus

[Markus_Bieler]

yes I knew all that.

I have a A4000D with A3640 rev 3.1

I will check if "Slow moe" will change anything. But my cable is only about 2m total (intern and extern)

There are several jumpers on the board which aren't described in the manual. Does anybody know anything about them?

Markus

[Markus_Bieler]

Perhaps this helps:

[color=CC0000]Fastlane.rom 8.5[/color]

Markus