Blizzard 1260 (with 68040@40 MHz) and SCSI cards...

[wurzel]

flaviosr wrote:

I have ONLY the z-3i SCSI device!!!
I tried also with others (but with a z-2i busboard) and the Blizzard does not work with ANY SCSI cards!!! I do not know it this is a problem of my card or if there is something I can do (jumper, setting, something else...).
It does not even work with my Blizzard SCSI kit in a standar A1200!!!

There is your problem!

You need to have 1230scsi.device because that is the driver.

With your Blizzard cards, you should have received the disks which contain all the software you need to enable the cards to work

You need 1230scsi.device installed.

[wurzel]

motorollin wrote:

wurzel wrote:

You need 1230scsi.device installed.

No you don't. 1230scsi.device is in the ROM of the SCSI interface. When the SCSI card is attached, 1230scsi.device is made available to the system immediately. There is no requirement to copy it from an install disk.

--
moto

Ok, I bow to your better knowledge, but, then, why does he not have it showing? He said he only had another device, not 1230.device?