mobo dead?

[amazing]

ok guys i have a little problem

i have an unexpanded a1200

when i turn it on it doesnt spin up the harddisk
on my other the harddisk works fine

if i boot it up on diskette it shows no memory at all?
my mouse can only move up or down?

what will be the problem? a chip dead? or sonthing simple?

all help needed

greetz Amazing

[amazing]

mm i replaced the roms..3.0 with 2 of my other board and still the same thing?

must be somthing real bad i think?

someone know some other tricks?

[amazing]

ok i also disconnected the keyboard?
does that affect anything?

[amazing]

ok if i boot it up with nothing but a psu and monitor

i get the kickstart screen showing the 3.0 roms and the disk inserting all the time

as for the mouse and all other stuff i used from my working other main a1200

i bought this 1 of from ripoffbay as a working unit
i mailed the guy and he said he tested it before he shipped it (sure and i go to bed with kendra wilkinson)

ok so what can i do now? throw the board away and buy a new mobo?
or can someone repair it?

[amazing]

ok...i went a little mad andthrowed the board thrue my room

after that i conected it again and started over

now the mouse works again ..andi see the full graph memory

ok now the othr thing...the h/d?

i can doh/d toolbox and then its a unknown h/d?
but i want to boot it? how to configure that?
i dont wanna loose all stuff on i

[amazing]

i was thinking? cold it be that the guy ripped of 3.1 roms

so t wont boot up anymore on it

[amazing]

thats the problem...i have tested the harddisk on my main amiga with 3.1roms and the h/d boots up fine...even all programs on it works

but if i load up the 1 faulty a1200 with a install diak of 3.1 wb i can go to h/d toolbox and read the config of the disk

but idont wanna delete anything on it..i just wanna boot up on it?
any other ideas?

ok when i turn power on i hear the disk spinup..to a certain point...then it goesinto the kickstartscreen

[amazing]

ok..i found out that when i go into the early startup menu and then say boot it will boot up on h/d?

so is this just a prob of some software settings?

who can help me out?

[amazing]

the strange thing is that it boots fine in my other a1200?

only 1 difference is it has a blizzard 030@50mhz?

but i think thats not a prob?

[amazing]

heheheehhe i found the problem....

if i put the blizzard in this a1200 it bootsup fine?

is there some settingi can turn off ? i gues it looks for the blizzard?