Next Steps - More EXPERTISE needed...

[rkauer]

On UAE config sheet, when you select the drives you want to mount, simply choose a higher priority to the drive you wish to boot from.

[rkauer]

I think your best bet is reinstall the WB 3.0.

 Once you have a LEGAL Amiga to run it, it's ok to download a set of WB 3.0 disks and use it in the WinUAE in order to make your hd up and running again. Simply put the six images in the UAE virtual drives (df0: thru df5:)and boot from the install one (1st disk of the set).

[rkauer]

 BTW: keep your actual 68040.library (/me thinks you have a 68040 or 68060 CPU, the one supplied in the disks are a bit old, even incompatible with your H/W).

 And that's could a cause of the misbehaving of all things: you need the image ROM matchs your actual ROM and the processor choosed in emulation needs to be exactly the same, too.

 Bear in mind that are two different types of 3.0 ROMs: for A1200 and for A4000/A4000T.

[rkauer]

motorollin wrote:
@rkauer
That link is illegal. Please remove it. Mallette has an email address in his profile, so if you want to provide him with links to illegal software you should send them that way instead of breakng the posting guidelines by posting a link.

Thanks

--
moto

@Moto.

 As we discussed here before in many times: the link is only for WB 3.0 (original C= grab, not 3.1/3.5 or 3.9) and is intended for ppl who really have a 1200/4000, no use for other machines. And I don't hosted it.

 Sorry if anyway I offend this comunity doing this. The post was edited to remove the link, BTW.

[rkauer]

 Ok, ppl.

 Moto has a valid point. I forget the guidelines of the board.

 Let's concentrate on Mallette's problem: the Simstation don't boot.

 I have an idea, but I may be wrong in the way it can be done: you can install SnoopDOS (aminet legal link) in the startup-sequence in order to catch the misbehaving library, then correct in dos mode only. :idea:

 But I'm unsure if snoopdos can run in dos mode only...