Problem upgrading to OS3.9

[rkauer]

Hello all ppl.

I have a persistent problem when try to upgrade my 1200/030(52 MHz) - 130 Mb RAM - ROM 3.1 - HD 4.3Gb - etc, to OS 3.9 (original).

Every time I try it, when the installation is done, rebooting then every time I try click on ANY icon (even on emergency disk icon), I got a 8000 0004 guru.

Nothing wrong happens when change the OS again to 3.1.

I have make a full backup of the system on another partition, format the boot one, install a plain 3.1 plus IDEFIX demo. No luck at all.

BTW: the other 5 partitions are SFS 1.236, the boot one is FFS 45.4 (upgraded, obviously). Could be this the problem? I tryed to format the partition with FFS 40.1 too, no luck.

Can anyone help me in this issue?

 :boohoo:

[rkauer]

Hi everyone!

Like Jack the ripper could say, start from parts:

- I just don't use the SFS in the boot partition YET (Ooooooooh , I'm just too lazy); ;-)

- Amidock is disabled;

- Maybe could the startup-sequence in the emergency disk is a "tweakedcopy" of the 3.1 original one? I didn't look inside it 'till now;

- In 3.1 I boot with the "CPU FastROM burst datacache databurst instcache"  command, could be this?

- In other partitions I have NIcons 4.3 images installed.

I only could boot in 3.9 if using early startup control "without startup-sequence", i.e., no GUI.:madashell:

- I have to change the original crystal, but 52 MHz is almost no difference at all (run fine in 3.1 with a lot of patches and programs on WBStartup and startup-sequence), not even a single guru). 4% of speedup is nothing to worry about (and I  put coolers and a fan inside the case, BTW).  :-D

[rkauer]

motorollin wrote:
Again, did you boot from the Emergency Disk when you partitioned your HDD and installed the OS?

moto

Nope, I just format the hd with original hdtoolbox and reboot the system with the emergency disk.

In order to partitioning I must make a full backup of hd before via UAE (I hate to open the Miggy and take the hd away in order to put it in a UAE peecee).