A500 A1000 Clockports ?

[Gilloo]

I simply could not figure out how to get the Anaiis software installed so never got the Subway working on the A500 with WB2.1.

More easier, you die...
go on aminet, type anaiis and download the anaiis.lha, extract files on a real amiga...
copy bin/anaiis and bin/usbstart and their icons where you want on a disk, and that's all.

If the clockport base address is not 0x00d80001, you should select "Subway" in the  preferences/system tab of ANAIIS program and put the real clockport base address in Param1.

At this step you can use keyboard, mouse, printer (usbprint), paddle (playhid) and disks (massive)

Don't give up :-)

[Gilloo]

Perhaps adding usbstart to s:s-s too?

yes, but before you should test the clockport, then if success, put the following into the s:startup-sequence

stack 8000
run >nil: sys:system/usbstart

[Gilloo]

Does Anaiis support the Deneb?

I fancy having a play with it.

uh no, neither Deneb, nor Algor. Only Highway and Subway (and perhaps thylacine if you put thylacine.usbhcd with the good parameters...) lack of docs, time and so

[Gilloo]

Great, and according to this you could run it with WB1.3:

At minimum, you need:
- Amiga 68000 at 7.14MHz
- a Highway or a Subway card
- some RAM (70 Ko for a mouse and a keyboard)
- should operate from WB1.1 to AmigaOS4.0 (680x0 cpu required).

I guess there is no way to boot from this sort of setup?

I know, I've done it
For the moment you need a boot disk (harddisk or floppy) to start ANAIIS.
(remember the TDisk wasn't bootable )

I working on a resident (or better a romable) version, but it will come after a better use of the uhc124.
Actually, massstorage is limited to 4kB/s but highwayxp.usbhcd can go up to 20kB/s with the Highway card (measured on a 68000@7.14Mhz) and there is certainly a tip to go up 200kB/s. It's the reason why 4GB thumbs take 5 minutes to mount (around 4MB of data is read by fat95 handler)

[Gilloo]

Thank you for keeping it so low spec, cli...

I try to make code working with all KS and all 680x0 processors (all Amiga to make short ).
Not sure that the mount command exists in KS1.1, so the massive and printer program are outside the stack.

If you have issues, don't hesitate to report them.