Next Steps - More EXPERTISE needed...

[motorollin]

If I understand correctly, you have a real Amiga hard disk connected and a virtual HDF, both configured in UAE, and you want to control which one it boots from. Is that correct? If so, you just hold down both mouse buttons after starting the emulation to get in to the early startup screen, and then select which drive you want to boot from and click "boot".

--
moto

[motorollin]

@Mallette
You need to press both mouse buttons down immediately after you start the emulation, before it attempts to boot from a drive. Keep them held down until the grey early startup screen appears.

@JJ
Yes that would work, but would be much more complicated than just selecting the boot device.

--
moto

[motorollin]

@rkauer
That link is illegal. Please remove it. Mallette has an email address in his profile, so if you want to provide him with links to illegal software you should send them that way instead of breakng the posting guidelines by posting a link.

Thanks

--
moto

[motorollin]

I have read (and participated in) the discussions about this before. However personal opinions on the distribution of copyrighted software do not change the posting guidelines of this site.

I appreciate you removing the link. Now lets not let this spiral in to another discussion about piracy and try to concentrate on helping Mallette :-)

--
moto

[motorollin]

@guru-666
Once again you have completely failed to see the point of my post. I expressed no personal opinion about the practicalities or morality of protecting ancient copyrights. I merely stated that it is against the terms and conditions of this site to spread copyrighted material. Fortunately rkauer is mature enough to realise this, and I respect him for that.

@rkauer
Yes, I think SnoopDOS will run in DOS, and that is a very good idea. But he would need to put "run" before it to allow him to return to the CLI prompt. Then the SnoopDOS log should show what library it is trying (and failing) to load.

--
moto