Workbench 3.1 not booting

[dougal]

I installed workbench 3.1 on my A600 with Kickstart 3.1 rom .

Everything installed fine but when i reboot i just get the AmigaDOS screen and no commands work .

It wont take any commands and loadwb does not work .

If i boot with floppy i can see that it installed in the HD .

What is wrong ?

There is a Startup-Sequence in S

[dougal]

alexh wrote:
Broken ROM?
Broken RAM?
Corrupted Hard drive?

Did you set the MAX TRANSFER value correct for IDE hard drive in HDToolbox when preparing the hard drive?

I didnt prep the HD . It was previously installed in an A1200 and had OS3.9 installed .

I just did a Quick Format and installed 3.1

[dougal]

countzero wrote:
wht's the size of the HDD ?

500Mb or something

[dougal]

Karlos wrote:

dougal wrote:

countzero wrote:
wht's the size of the HDD ?

500Mb or something

When you boot from the floppy, can you directly read the contents of the hard disk?

If, having booted from floppy, you type:

DH0:C/list DH0:

does it work?

If i boot with a workbench floppy i can see the contents from workbench

[dougal]

Karlos wrote:
Ok, this is starting to sound like the disk is installed but the partition is not bootable for whatever reason.

If you boot with both mouse buttons held down and get the early startup screen, do you see the hard disk partition in the list of bootable drives?

If it is not bootable, something went wrong before or during the install, but it should be fixable.

Having booted from floppy, can you find the HDToolbox program? It should hopefully be under the Tools directory on your hard disk.

It has been a long time since I saw OS3.1's HDToolbox program, but you should be able to select whichever partition you installed the OS on.

You need to check that it has been made bootable (there is a checkbox somewhere) and that the filesystem is supported. If it is anything other than FFS, you might have a problem. The fact that you can see it when booting from a floppy tends to suggest it isn't the filesystem, unless the floppy has had the filesystem installed on it.

Assuming it is FFS and the partition is not checked as bootable, all you should need to do is tick the bootable checkbox, save the changes to the drive and reboot.

It is bootable and it is FFS  :-?

I will have another go installing ... this time i will prepare the HD and partition it again , all afresh as it previously had OS3.9 installed on it (from my A1200)