SCSI to SATA adapter?

[mechy]

So been thinking with SSD drives becoming the norm I was going to try one on my Video Toaster Flyer. Is there such a thing as an affordable SCSI to SATA adapter? Ive seen some but they are well over $100 and that seems outrageous.[/QUOTE

They were affordable(the 7720u,7722,7720uw etc) were affordable and downright cheap on the used market for many years, but they have been snapped up by everyone and are more costly now. the 7730a was for 68pin uwscsi to sata. i currently use it in my 4k with a samsung 850 pro ssd. there is the same thing under addonics name(i think i got it for $79? new a year or 2 ago). addonics # is ADSALVD160 just a rebadged acard. the firmware upgrades work on it from acard site. you might find a good price with some google digging. any of the above would work to use a cf in a ide to cf adapter(except 7730a and addonics which is sata).


another option might be:
http://www.ebay.com/itm/CF-AztecMonster-CF-3-5inc-SCSI-Converter-New-Condition-for-Vintage-Computer-/301820877738?hash=item4645ed1baa:g:F3MAAOSw1XdUXEEp

Not any cheaper though ;/

I dont think the scsi2sd will work for a flyer, its pretty darn slow:

http://shop.codesrc.com/index.php?route=product/product&product_id=58

i think amigakit sells these cheaper,at least i believe it to be the same thing. they run maybe 2 MB/s so it may be too slow for video.

[mechy]

This one looks interesting,
https://www.itead.cc/scsi2sd.html?gclid=CNrusevv28kCFQEaaQodc4EACA

Would the transfer rate be fast enough, Any thoughts?

That is the same thing i showed above, amigakit sells them now and a host of others.. they only do around 2MB/s i believe.

[mechy]

This one looks interesting,
https://www.itead.cc/scsi2sd.html?gclid=CNrusevv28kCFQEaaQodc4EACA

Would the transfer rate be fast enough, Any thoughts?

check the disk speed of your current setup. maybe use it to compare. Other wise the only way to know is to buy one and try it

[mechy]

The Aztec works fine in my A3000.  I have the newer SCSI chip, and I had to disable termination.  After I got that working (about 3.75MB/s), I put it on my Warp040 board's SCSI... now I get 8MB/s.  

Those should be pretty fast since he just integrated the acard 7720 with a cf into 1 board. some people have reported problems with them,but hard to tell if it was just a termination issue or missing term power(diode d800 on 3000 bad or wrong way round?). Might even be the firmware rev.

It is too bad there is not a $50 version of it. Maybe someone should build one(hint jim hint hint)