Indivision will not fit on all 1200s

[Schoenfeld]

If there's a resistor near the HP Lisa chip, it's a rev.2b motherboard, and it's compatible with Indivision AGA 1200, just like all other A1200 motherboards are compatible.

The sockets of the first batch of flickerfixers were only filed down on the spot where this resistor is near. Since HP Lisa chips seem to have a wide variation in height, the second production run was already changed, and sockets were lowered 0,2mm total with power tools.

For the A4000d/CD32 version, we did this prior to production. I took pictures of the tools we've built/used to make the sockets fit perfectly:

http://www.a1k.org/forum/showpost.php?p=240534&postcount=874

The text is in German, but you might be able to babelfish it.

Jens

[Schoenfeld]

murple wrote:
Yeah, it is a 2B board. I don't have very fancy tools and I'm not really eager to start filing on something that cost as much as this did. If I can't get a replacement motherboard...

Don't make a fuzz about the motherboard - it's perfectly OK. Indivision isn't. Send it back under warranty, and either your reseller, or I will take care of it.

Jens