CV64/3D and scandoubler

[snowman040]

Hi,

I bought CV64/3D and scandoubler for my A4000 but without 10 pin cable that connects them. Does anyone know how to make cable ? What are pinouts ?

After making the cable - do I connect monitor to cv64/3d or scandoubler for Amiga pal screens ?

regards,

[snowman040]

I posted this problem on http://www.amigaforums.com and wizzchris told me that he tried his cable and it seems like 1-1 cable

1
:::::
1
:::::

I made cable like that, but scandoubler returns some silly out of sync freq to it's output. However, when booting to CGX - CV64 doesn't work with this 1-1 cable - only when I remove it...

However SD seems modified, like this: http://brunsweek.metrohive.net/mod.jpg (green wire) is connected to one pin on BT chip. Any clues ?

Is there some jumper setting to allow scadoubler to work ?

regards,

[snowman040]

Manual downloaded - still nothing

To demistify few things:

1. CV64/3D works fine, CGX installed, WB all - no problem there.

2. ScanDoubler when connected to monitor (not to CV64 by 10pin cable) gives some kind of picture - but it's under sync'd. No metter what jumper settings.

3. When I connect SD to CV64 with 10pin cable (1-1) - nothing happens with SD, but CV64 goes crazy sync (like SD is doubling VGA mode), when I remove 10pin cable pic comes back to sync.

4. I made 1.2-2.1 cable (mirrored) and when I connect it - picture on SD dissapears, and nothing is on CV64 again - no metter what jumper setting are.

Can SD work by itself ? Or CV64/3D must be connected to it? I only want to play games

regards,