Welcome, Guest. Please login or register.
Forums
« previous next »
Pages: [1]   Go Down

Author Topic: Look what I found: Joysticks $3 NIB (slik stik)  (Read 5140 times)

Description:

0 Members and 1 Guest are viewing this topic.

Offline Anonymous MOS

  • Full Member
  • ***
  • Join Date: Jan 2004
  • Posts: 192
  • Country: us
    • Show all replies
Re: Look what I found: Joysticks $3 NIB (slik stik)
« on: August 10, 2007, 06:28:36 PM »
They must have been running short on parts.  The one I have uses a shaft of steel that was machined into a ball at the bottom.
Logged
 

Offline Anonymous MOS

  • Full Member
  • ***
  • Join Date: Jan 2004
  • Posts: 192
  • Country: us
    • Show all replies
Re: Look what I found: Joysticks $3 NIB (slik stik)
« Reply #1 on: August 10, 2007, 06:46:26 PM »
Hmmm, maybe they ran short on parts on mine...  Mine doesn't have any rubber inside, just a steel shaft.
Logged
 

Offline Anonymous MOS

  • Full Member
  • ***
  • Join Date: Jan 2004
  • Posts: 192
  • Country: us
    • Show all replies
Re: Look what I found: Joysticks $3 NIB (slik stik)
« Reply #2 on: August 10, 2007, 08:36:28 PM »
Mine is set up to use gravity to self center.  The stick and top of the joystick are flat so the weight of the stick self centers it.
Logged
 

Offline Anonymous MOS

  • Full Member
  • ***
  • Join Date: Jan 2004
  • Posts: 192
  • Country: us
    • Show all replies
Re: Look what I found: Joysticks $3 NIB (slik stik)
« Reply #3 on: August 12, 2007, 05:25:39 PM »
No, no rubber at all, hard plastic on hard plastic.  Not much room between each.  I guess so it centers properly.  The cuff is very long, between the stick plastic and the casing plastic, then after that, just steel.

I might take a pic just so you can see it, since I can't describe it very well.
Logged
 
Pages: [1]   Go Up
« previous next »