Good cooling solution for CyberVisionPPC?

[cv643d]

So my big bad blue anodized Zalman heatsink that I super glued on each corner of the Permedia chip fell of my card today when I removed it from my A4000.

Maybe just as well, it did not cool GFX-board that good, it got really hot. I suspect you really Really need a fan on the P2.

I need to find another solution. Prefearably one where the heatsink is attached to the graphics card with screws, and a heatsink that will take a 30 or 40 mm fan.

No, -duct tape, wires or zipties wont do it for me 8-)

Anyone got a solution to the problem?

[cv643d]

I actually used thermal compound also, but I left four tiny spots for super glue on the corners. Its an old way of mounting heatsinks, goes way back when the blow hole and fanbuss was invented.