CSPPC scsi part not working

[amiga4001]

I purchased me a used csppc and am testing it now.
Works ok with os4.0 so ppc is ok.
But can not get a scsi drive going.
No matter what I try is deosn't show up.
This while with my other csppc it show up nicely.
So guess scsi part is broken.
Connector on ppc looks a bit worn..I tried to bend the pins a bit inside the connector and sprayed a bit off contactspray onto it.
Still no go.
Are these more common to fail?
Anyone managed to get it repaired at what cost etc...
Still could be usefull I guess with a fastata or something.
Gotta think what to do with it.

[Amigaz]

Have you pressed ESC during boot to check that not the SCSI ID you have for the harddrive is disabled?

(The CSPPC early startup menu)

[amiga4001]

Yes the unit should be enabled.

[alexh]

If you are using an A3000 you may need the INT2 modification?

[Matt_H]

After upgrading the firmware of my MK3, it stopped recognizing my hard drive. Turns out the newer cybppc.device was a *LOT* more sensitive to SCSI issues. Changed some (non-ID-related) jumpers on the drive and all was well.

So check your jumpers or try a different drive.

[Amigaz]

Agree with Matt H

Have had these problems too with both my CS PPC + CS MKIII with some 68pin HDD's

[AMC258]

If you are using an A3000 you may need the INT2 modification?

The SCSI works without INT2.  It just takes an eternity to boot.

[CLS2086]

Check the 68K part as it handle the SCSI.
I had a similar problem with my BPPC.
JJ Boulet (amiga center) repaired it.

[amiga4001]

It is running on an amiga4000.
Cybppc.device are different versions I believe between the two.
Will try some jumpering.
Hardwarewise there isn't much you can do me think.