Hello,
I am trying to move things from an old crapped out amiga 500 to a slightly less crapped out amiga 500. I took the hard drive and plugged it into the new one, then I looked in a little compartment under the amiga and the old crappy one had a card in there and the other didn't so I decided to swap it over.
However it doesn't seem to plug in all the way... i measured the pins and they are 7mm on each machine and i can't see anything that is blocking it, I took it out and put it back in the original machine and it fits nice n easy.
I've tried giving it a bit of elbow grease but i don't want to break it, and I'm guessing since it isn't plugged in all the way this is why the machine doesn't boot
Any ideas?
Thanks,
