A4000T WB3.1 install on ZuluSCSI

[VmanJeff]

So I have a A4000T with 3.1 OS and roms. Attached a ZuluSCSI and created several ‘harddrives’ and made a 100meg boot partition. The tower normally boots from a SCSI drive of the 90’s era. Decided to do a fresh install of 3.1 on the ZuluSCSI for eventual upgrade to 3.2 or more depending on what the system can do (catch-up learning after years!) I don’t want to make a duplicate of the present WB since I’m having some other issues recognizing the X-surf and it’s IDE drive so figured I’d start fresh and work that issue.
I booted from workbench floppy and installed the OS on the ZuluSCSI.  Rebooted holding both mouse buttons down and chose the Zulu partition and she boots fine. For some reason I decided to disconnect the old boot drive just to confirm and then she won’t boot. There was a screen that flashed very fast in the startup then nothing but the workbench header. I had to video the startup to catch it. Not sure where to go from here

[VmanJeff]

Here’s the startup screen I get

[Thomas]

Copy libs/workbench.library from the old boot drive to the new one before you disconnect it.

For an A4000T you need special install disks because the ROM lacks workbench.library.

[VmanJeff]

Oh that’s right. They left it off. But shouldn’t 3.1 have installed it!?  The floppies are specifically for the Tower. I’ll look and I’ll try it if it’s not there.